Jump to content
  • Welcome to the eG Forums, a service of the eGullet Society for Culinary Arts & Letters. The Society is a 501(c)3 not-for-profit organization dedicated to the advancement of the culinary arts. These advertising-free forums are provided free of charge through donations from Society members. Anyone may read the forums, but to post you must create a free account.

Sous Vide: Recipes, Techniques & Equipment (Part 1)


Fay Jai

Recommended Posts

I've always used propane with my blowtorch, but I thought there was some concern as to the safety of a propane flame when in direct contact with food to be consumed. I'm aware that most grilling is done w/ propane but isn't this different since you risk "contaminating" your food with byproducts from unburned propane (or something)

Link to comment
Share on other sites

Cheaper would be a crock pot and a PID, but a DIY project.

PID being?

My crockpot's "Low" setting is about 170 degrees. I've been thinking about getting a smaller one just for Sous Vide, but if I can regulate the temperature some other way, I might consider that. Like a reverse Wine-Stat :biggrin:

Here's what Rival has to say about crockpot temperatures.

We can not specify temperature ranges for the "High" or "Low" settings. Our slow cookers differentiate "High" and "Low" by wattage. These wattages are set to ensure that a standard food load (as described in AHAM spec SC-1-1979) will reach a safe internal temperature within approximately four hours. The wattage required to do this is different for different models, and many variables are involved; (start temperature, food load, room temperature, etc.). Eventually slow cookers will reach a maximum temperature, however the temperature will be different for different environmental conditions and different food loads. Given enough time most food loads will reach the same maximum temperature on both "Low" and "High."

Gastronomic Fight Club - Mischief. Mayhem. Soup.

Foodies of Omaha - Discover the Best of Omaha

Link to comment
Share on other sites

I always attempt to have the ratio of my intelligence to weight ratio be greater than one. But, I am from the midwest. I am sure you can now understand my life's conundrum.

Link to comment
Share on other sites

To bring the thread back to page 1 (!):

Any experience with doing lobster tail sous vide? Suggestions on time and temperature, perhaps? I'm wondering whether a fast immersion at 190 (Keller butter poaching style) is the way to go, or whether LTLT will help (or, even better, if there's a particular "alchemy temperature" that does for it something parallel to what 104 F does for cooking salmon fillet).

Mayur Subbarao, aka "Mayur"
Link to comment
Share on other sites

I have done lobster sous vide several times. You need to get the lobster out of teh shell and there are two approaches to this. One is to kill the lobster and cut it up, removing flesh from shell. The other approach is to briefly pour hot (but not boiling) water over it, then proceed to cut it up. This is what Keller, and several other chefs, suggests. The hot water is just poured over the lobster, then poured off, so is only on the lobster for seconds. The advantage to the hot water method is that it loosens the flesh from the shell, claws etc.

Once you have the lobster meat separated (claw or tail) put into a sous vide bag - I ususally include some butter, and potentially some seasoning depending on teh recipe. I cook it at 45C/113F until cooked through (depends on thickness - see the fish time tables in this thread).

Lobster comes out wonderfully sous vide - it is tender and perfectly cooked.

I do shrimp and prawns at 45C/113F also.

Nathan

Link to comment
Share on other sites

What's the best kind of fuel to use when blowtorching a sous vide protein?  I know there has been some disagreement about this on other threads but what type of fuel canister should I be buying?

I don't use a "fuel" per se, just a 1200W dual temperature electric heat gun from the local Ace hardware store. On high it gets up to 1000F which is enough to roast a pepper or brown a turkey or remove paint.

Doc

Link to comment
Share on other sites

Good idea with the heat gun. I've got a couple of those lying around, so I'll give them a try.

My water bath from eBay is currently in transit--in Kansas now-- and should be here by the end of the week. I'm anxious to start experimenting.

Link to comment
Share on other sites

My water bath from eBay is currently in transit--in Kansas now-- and should be here by the end of the week.  I'm anxious to start experimenting.

Bryan what have you ordered? Most of the water baths/circulators offered on eBay come with the caveat that it "powers on" but other functions have not been tested. Please tell us what brand and model you bought and whether or not it works as it should. I am desperate to have one but very timid about buying on eBay

Ruth Friedman

Link to comment
Share on other sites

I bought an immersion circulator on ebay that worked perfectly. The seller had a ten day return policy. Unfortuately, the wire that attached to the temp. probe shorted out (I didn't know it shouldn't get wet) and the repair costs exceed the price I paid on ebay. I just bought another immersion heater (after getting confirmation from the seller that I could send it back if it didn't hold its temp.). Hopefully it will work as well as the first one -- and last longer than a few weeks!

Link to comment
Share on other sites

I have bought lots of items on ebay, and they almost always work. One water bath died after being used for a while, but it is hard to blame the seller because it worked for many months. There are risks in ebay, but that is also why things are cheap.

There are used laboratory equipment dealers that offer somewhat more in the way of checking that things work, but they are also more expensive.

Nathan

Link to comment
Share on other sites

Bryan what have you ordered? Most of the water baths/circulators offered on eBay come with the caveat that it "powers on" but other functions have not been tested. Please tell us what brand and model you bought and whether or not it works as it should. I am desperate to have one but very timid about buying on eBay

I purchased a VWR 1203. I looked up its specs. online and it looks pretty legitimate. It's not a circulator though, but I don't think that should be too much of an issue. I paid $150 + $25 shipping for it. Not super cheap but a hell of lot less expensive than if I had bought it new or tried to use a used equipment reseller.

This unit does not have a return policy on it. I did correspond with the seller, however, and he informed me that the unit does hold temperature etc. One wonders why a lab would throw out a perfectly good hot water bath, but I'm banking on some good luck.

On a separate note I have a sous vide questions that I haven't seen discussed yet:

How does one cook something like a duck breast sous vide? Does one have to render out the fat first, or will the sous vide cooking process provide sufficient temperatures to melt that fat away? Any suggestions?

Link to comment
Share on other sites

On a separate note I have a sous vide questions that I haven't seen discussed yet:

How does one cook something like a duck breast sous vide?  Does one have to render out the fat first, or will the sous vide cooking process provide sufficient temperatures to melt that fat away?  Any suggestions?

There are as many ways to cook duck breast sous vide as there are to cook it in other ways.

The classic French approach to duck breast is to treat duck breast like the red meat that it is and cook it to medium rare.

I use a water bath at 131F/55C, I cook until the core reaches 130F/54.4C (see tables in this thread for the times). If you like you can then let it cook an additional there 20 min to 30 min for food safety.

Many French chefs serve duck breast even more rare than this - cooking only to 120F/49C. This is a matter of personal preference. A bunch of other chefs will worry about cooking it at that low temp and will cook it at 141F/61C instead, but I don't like like that hot.

You could, in principle, cook duck breast for a very long time (12 to 36 hours) at low tempertaure (I would use 131F/55C) to tenderize it similar to other kinds of red meat. Obviously this depends on the ducks as to whether the breast meat is tough or not. Given the duck that I use, I have not had to do this, but it is an interesting possibility. It would also be interesting for duck legs - traditionally one cooks them at higher temperature because the legs are tougher, but with long time cooking sous vide they might be fine this way. Something to try...

No fat will render at any of these temperatures, so you have two choices - serve the breast without the skin, or crisp the skin by searing under intense heat (broiler, blowtorch, griddle). Any method of cooking which renders the fat will ruin the meat under the skin. If you really want duck skin that is thin and crispy without a fat layer, you have to remove it from the meat and cook it separately.

Or you can overcook the duck breast, if you prefer (can you detect my point of view :smile: ), by cooking it at higher temperature. As an example, you can make duck breast confit by cooking it at 180F/82C - there is a whole thread on duck confit that discusses sous vide approaches. These approaches work for the breast too. Traditionally one uses legs because they were not useful for other dishes (too tough) so they were cooked as confit to make them tender and also preserve them.

Note that even cooked at confit temperatures for 8-12 hours, the skin will not render all of its fat, and will still need to be crisped or seared.

Nathan

Link to comment
Share on other sites

I'm goint to try stone crab claws sous vide and see how they turn out. My local fish monger has agreed to sell me 5 pounds of "green" claws off their boat and we will then begin the experiments.

First, there's the cooking times & temps. Is 113F internal temp enough? I'm thinking that quick chilling it in a super saturated brine solution should get the little buggers cooled off pretty quickly.

I've been warned that if we try & freeze the claws after they've been cooked, the sharp points of the shells usually puncture the bags and they get freezer burnt. Those little "napkins" that the butcher ships put under individually wrapped steaks at the grocery store are suppoed to help a little, but probably not enough.

My friend Jacques' bottom line on this is that if we can figure out a way to do this and keep the claws frozen, we may be able to supply claws on a year round basis and make a buck or two out of it.

I'll post updates as we learn more.

Link to comment
Share on other sites

Butchers use a special tough wrap called bone guard to prevent puncturing vacuum packing bags that have meat on the bone (like rack of lamb). You can buy it from meat supply place (on the internet), but a small wad (i.e. more than one layer) of aluminum foil over the sharp parts also works pretty well, particularly for sous vide cooking because it conducts heat pretty well.

I have not cooked crab, but I would start at 113F/45C. It works for fish, shrimp and lobster, so it should work for crab.

For timing use the tables based on the thickest part of the claw, then add some time. I am not sure how much because I don't have any data for the insulating effect of the shell. I have not tried cooking crab claws.

The best approach is to use a temperature probe - directions in this thread talk about how to do that using a piece of foam weatherstripping to keep the bag sealed. Of course it is hard to get a temperature probe in a crab claw, but you certainly could drill a hole in the shell up front. That is what I would do, particulary if you plan on doing a lot of these....

Another option would be shelling them raw. This takes the traditional whacking of the claw at the table out of the experience.

Let us know how it turns out.

Nathan

Link to comment
Share on other sites

So I got my water bath tonight (though unfortunately it arrived at my house after dinner). Anyway, after cleaning it with every solvent I had on hand, I attempted to set it up on my counter. I warn you, it's not a good idea to move a water bath when filled (it's 25 lbs without water and who knows how much when filled). Needless to say, I drenched myself, my countertop, my floor, etc.

Some have asked as to this water bath's condition and ability to maintain temperature. So far it seems pretty good. A little tempermental with the control knob (it's not exactly calibrated perfectly), but I think once I've got it at a set temperature it will stay there. I've only had it for a couple hours, so I'm still working that out.

I'll be posting my attempts at scallops, jumbo shrimp, wild salmon, duck breast, short rib, and god-knows-what-else sous vide over the coming days. For now, here's my equipment:

gallery_28496_2247_312171.jpg

Foodsaver v1205 with extended vacuum and instant seal. I decided that these two features were important and finding a model that had both these and a reasonable price was quite annoying.

gallery_28496_2247_124413.jpg

gallery_28496_2247_417011.jpg

The water bath with my thermometer inside it. I need to get that temperature down to 45 C.

Link to comment
Share on other sites

percyn, was the "D'artagnan Duck Confit" already confit-ed by D'artagnan? I assume that you made confit out of a D'artagnan duck leg using sous vide technique? If it was already confit, I would think that cooking it LTLT sous vide amounted more or less to very complicated reheating.

--

Link to comment
Share on other sites

Slkinsey,

You are correct...I was essentially heating the duck confit, while I was really making this....

Short ribs - in the Sous Vide machine after 36 hrs @141 F.

gallery_21049_162_8202.jpg

Served with a porcini and bordeaux demi glace sauce sprinkled with some fluer de sel

gallery_21049_162_65732.jpg

The texture was like that of a very tender steak, as opposed to the "pot roast" like texture I get with my traditional braising method.

Link to comment
Share on other sites

The Sous Vide experiments continue...

Seasoned rack of New Zealand lamb at 138F for 5.5 hrs

gallery_21049_162_28381.jpg

Before putting it under the broiler

gallery_21049_162_66084.jpg

The meat was light pink (no red) throughout, but very tender

gallery_21049_162_15743.jpg

Plated after covering with mustard, panco bread crumbs and placing it under the broiler for a few minutes. Also made a sauce from lamb jus, demi glace, red wine, shallots and pomegranate molasses

gallery_21049_162_84680.jpg

The end result was one of the most tender pieces of lamb I have ever had. Next time I will try to shorten the cooking time a bit and also place the lamb under the broiler before covering with bread crumbs and then again after coating it in bread crumbs.

Hmmm hmmm goood !!!!

  • Like 1
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...